Installation Guide

Good design deserves a decent install. Here’s how to get it on the wall — quick, simple, tidy.

This installation guide is for all shelves in the range.

TOOLS NEEDED
• Drill
• 3mm drill bit and 6mm drill bit
• Philips screwdriver
• Level
• Pencil
• Hammer

WHAT’S INCLUDED
• 8g x 25mm screws
• Twist-n-lock wallmate plugs (for gib with no timber behind)
• Standard wall plugs (for gib with timber behind or other surfaces)

INSTALLATION STEPS

1. Mark Holes
   Hold the shelf where you want it. Use a level. Mark your holes with a pencil.

2. Prep Wall
   • If going into Gib, use the 3mm drill bit to make pilot hole
   • Gib (no timber behind): Twist in the wallmates with a screwdriver.
   • Timber or other surfaces: Drill 6mm pilot holes, then tap in wall plugs with a hammer.

3. Position Shelf
   Line the shelf up with your holes.

4. Insert Screws
   Screw into plugs with a screwdriver. Don’t crank them too tight.

That’s it.
Job done.

Step back, take a look, and enjoy the fact it’s now Well Placed.